Design, use Precautions

Notes on design

• In the filter press selection process, should be strictly in accordance with my company provides the filtering pressure of products designed to order, so as not to affect the machine's filter effects and the plate of life;

• conventional products can not be used for anti-riot situations. The user, if explosion-proof requirements, please note when ordering a special explosion-proof rating and the use of the environment;

• in product design, if the filter temperature exceeds 80 ° C, in the special instructions when ordering, if the ordinary plate as a heat plate to use, will affect the plate of life, and even damage caused by plate;

• during the foundation design of filter press in order to provide drawings of the subject, and the two feet placed on the location of load-bearing beams. Operating manual of the foundation plans only for reference. Improvement of the product affected by equipment, form, foundation size and so on, without notice to users;

• filter press lifting should be hooks hoisting equipment, hole, and identify the center of gravity after the lifting equipment;

• filter press installation, the device should be thrust plate and the cylinder block of the level of the installed base of legs is controlled at less than 0.5/1000;

• Filter Press twice to cement grouting of anchor bolts, exposed screw 50 ~ 65mm;

• filter press installed in place, the primary beam filter press should be measured the level of degree, and control within ± 2mm, two main beam of the right angle deviation is less than 4mm. Otherwise, filter press in the course of Shouli Bu are a result of deformation caused by the main beam;

• the selected filter cloth specifications different from its thickness is not the same, and sometimes lead to pull board cake discharge from the open block has changed and is a normal phenomenon, selection should be attention.

Notes on use

• had not received training, equipment and system maintenance personnel are not allowed to open the electronic control box wiring, or wiring errors may be caused by malfunction;

• Start a new filtration cycle, care must be cleared plate sealing surface of the filter cake residue, otherwise the resulting deformation of the main beam, plate rupture, running materials and other incidents, is not "three guarantees" in the column;

• opening the machine, they must confirm the start filter press will not cause personal injury;

• Do not open the filter press power electronic control box touch terminals, do not open the motor terminal box, or may cause electric shock, malfunction;

• filter press feed does not end when you do not release the filter, otherwise it would cause the filter materials leak, the operator will result in heavy casualties;

• filter presses electric contact pressure gauge and relief valve, such as damage must be promptly replaced, otherwise it would hydraulic station, high pressure cylinder in a state of long-term shortening the service life of hydraulic stations and pipelines, causing oil pipeline rupture, causing the fuel tank burst;

• filter presses or pull pressed board, please do not order between the filter cloth stretched its hands into the plate, otherwise it will result in personnel injury. If you want to order filter cloth, please stop or pull plate pressed state.

• Hydraulic standing operation, please do not open the hydraulic components, or high-pressure hydraulic oil will be spilled, assault, must be in the hydraulic pressure relief stations (pressure ≤ 0.05Mpa) removable rear hydraulic components.

• filter press commissioning should be in accordance with the requirements of the manual operation the hydraulic station hydraulic oil fill, otherwise it would not full of fuel tanks of filter presses, affecting the normal operation of hydraulic station and lead to pump damage;

• operating manual should be replaced periodically as required by hydraulic oil, and timely cleaning of hydraulic valves and pumps, hydraulic station will be affected and the normal work;

• feed pressure equipment does not allow more than the normal filtration pressure, otherwise it would cause plate breakage and deformation of the host;

• filter press for maintenance, the total power supply to be cut off filter press.