7, pay attention to matters

1, in the pressed plate before the plate must be arranged in neat rows, and close to the thrust plate side parallel to the thrust plate to place, to avoid errors caused by plate placed on the main beam bending deformation;

2, filter press in pressed, the pass into the slurry to work, feed pressure must be controlled at the factory nameplate on the calibration of the largest filtration pressure (gauge pressure) the following, otherwise it will affect their normal use;

3, filtering the beginning, the feed valve should be opened slowly at first filtrate are often more turbid, and then switch to clear, is a normal phenomenon;

4, slurry pump and the feed valve, washing pump and inlet valve, compressed air and the intake valve opens at the same time allowing only one of them;

5, due to capillary action cloth fibers, filtration, the plate sealing surface leakage between the clear liquid is normal phenomenon;

6, in washing cloth and plate / box, be careful not to let the water splashed on the fuel tank of the power supply;

7, removal, replacement plate / box, the force should be appropriate to prevent the collision damage, non-beat, impact, so as not to plate / frame break. Plates / box must not be placed in the wrong place; filtration can not be won without authorization plate / box, cylinder stroke is not enough to avoid accidents; Plates / frame break, should the timely replacement can not continue to use, otherwise it will cause other Plates / frame break;

8, models for the undercurrent of pipe installation, a liquid pipe should not be higher than the position of the mouth of fluid filter press to reduce the filtration of the fluid resistance, and should ensure a smooth flow of liquid pipelines.

9, electric contact pressure gauge (DY) pointer, the lower limit of the factory has been fine, users typically do not move, if the user wants to adjust the pressure, then the limit of no leakage shall prevail, the ceiling should not exceed 27Mpa;

10, high-pressure relief valve (YH) before the factory moved 27Mpa, if the user wants to adjust its own fuel tank nominal pressure, should be high-pressure relief valve (YH) all stressed pine, and then start the piston (B), slow Slow to adjust the pressure relief valve (YH) to the desired pressure, but not more than 27Mpa;

11, safety relief valve (YA) before the factory moved 29Mpa, the user must not be altered at random;

12, hydraulic oil (YA-N46, YC-N46) should be filled through the air filter into the fuel tank, must meet the requirements of oil. And to prevent the sewage and debris into the fuel tank to prevent rust hydraulic components, plug;

13, electrical box to keep dry, the pressure gauge, solenoid valve coil, and various electrical components should be regularly inspected to ensure that the machine working properly. Required to be closed after the shutdown of air switch, cut off the power supply.

14, fuel tank, cylinder, piston pump and relief valve and other hydraulic components are subject to regular cleaning no-load operating cycle method, in general, use of filter press working environment cleaned once every six months, the working oil filter accuracy 20μm. The new machine in the use of 1-2 weeks, the need for hydraulic oil, oil change, dirty oil will put the net, and to drain the fuel tank cleaned a second time for one month, after an oil change once every three months or so (also according to different environment appropriate to extend or shorten the drain).