100%

Limited colors (such as red, green, blue, yellow, gray, black etc. )

200-300µm is recommended.

3.3 m²/Kg (or 0.3 Kg/m²), based on dry film thickness of 250µm.

A: B = 4:1 (By weigh)

Airless Spray: Recommended. Tip range: 0.53-0.65mm; Total Fluid pressure: not less than 176 MPa
Brush or Roller: Suitable. But it is thick, should avoid running.
Air Spray: Unsuitable

In general, unnecessary. If needed, use OUP 103.

OUP 103

For Summer: 35℃: 30-45min; 25℃: 45-60min

For Winter:     15℃: 30-45min ;  5℃: 45-60min

Substrate Temperature

Touch Dry
(h)

Hard Dry
(h)

Completely cure 
(d)

Over coating Interval

Minimum

Maximum

35℃
25℃
15℃

5℃

≤4
≤6
≤6 

≤8

≤8

≤12
≤12
≤24

≤1

≤2
≤2
≤3

3
7
7

10

No limitation

Dry and cool conditions; Storage Life: One year

A: 16 Kg in 20 litre container;  B: 4 Kg in 4 litre container

＞65℃ (Mixture, A and B)

1.20-1.25 Kg/L

    Steel surface shall be rust-removed in accordance with St 2.5 by blast method or St 3 with power tool. The surface also shall be clean and dry. More importantly, the temperature of  substrate surface is at least 3℃ more than the dew point. 

    Recommend using the paint for summer when the temperature is over 20℃ at the application site and if it is between 0-20℃, use the paint for winter. To be attentive, this paint will cure very slowly below 5℃. In addition, it is unsuitable to paint with this paint product without heating installations in the condition below 0℃. 

     Must mix component A and B according to the practical necessary quantity. Recommend making this paint just before painting with it. Should stir to even before application. It is recommended to use up in pot life in case it would cure and could not be used.

      The appearance of the film depends on environmental temperature and humidity. Ambient temperature should be over 10oC and relative humidity is less than 85% for good appearance.

    This product should be used in painting area by professional operators. When painting, please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.

     Although this paint product is free of solvent, minimal safety precautions, as follow, should be done in order to avoid danger or accident:

     This paint is flammable, so must be far away from open flames.In general this paint has no danger of explosion. However, enough ventilation is necessary at application site.

     Because the paint liquid is harmful, protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eye protection, face masks, barrier creams and so on). If paint gets in touch with skin, wash fully with a large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately.

    Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in badly ventilated conditions.

Handle empty containers with care and do not bring about environmental contamination.

    NOTICE: If consumers haven't taken effective safety precautions (Refer to the specifications), our company will NOT be responsible for any accident.