55-60%

Black,  Grey, green, blue, red, yellow etc. Limited colors.

50-200µm, according to the surface condition.

4.4 - 5.2 m²/Kg, based on dry film thickness of 100µm.

A: B = 5:1 (By weigh)

Airless Spray: Recommended.
Brush or Roller: Suitable.
Air Spray: Recommended, thinning is necessary.

OUP 103

OUP 103

35℃: 2 hours;    25℃: 4 hours;     15℃: 6 hours

Substrate Temperature

Touch Dry
(h)

Hard Dry
(h)

Completely cure 
(d)

Over coating Interval

Minimum

Maximum

35℃
25℃
15℃

≤2
≤4
≤6

≤12
≤24
≤36

≤3
≤5
≤7

12
24
36

No limitation

Dry and cool conditions, Storage Life: One year

A: 20 Kg in 20 litre container;  B: 4 Kg in 4 litre container

＞33℃ (Mixture, A and B)

1.05-1.15 Kg/L

    Before application with this paint product, all cracks, joints, protrudent and hollow spot on the floor should be filled up and repaired correctly. And the surface has been applied sealer and paved with conductive copper film connecting ground, or other conducting coatings (Such as conductive filler or conductive intermediate coatings), Thus the surface must be smooth clean and dry.
    This product cannot cure fully at low temperature. The substrate temperature should be maintained above 10℃ for good effect.
    Must mix component A and B according to the practical quantity. Recommend making this paint just before painting with it. Should stir to even before application. It is recommended to use the paint mixture up in pot life in case it would cure and could not be used.
     After painting, may walk on the floor when the film is hard dry. It cannot be used until it cures completely

    This product should be used in painting area by professional operators. When painting, please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.
    This product is a kind of solvent-based paint. In order to avoid danger or accident, minimal safety precautions, as follow, should be done::
    The paint contains volatile solvent and is flammable. So must keep away from sparks and open flames. No smoking at application site. Effective precautions (such as using explosion-proof electrical equipments, no static electricity accumulation or metal collision etc) also should be done so as to avoid producing sparks. Flash point of paint, mentioned above on Product Data Sheet, is the lowest temperature at which mixture of the volatile materials of paint can ignite or explode with air, so we suggest painting should be stopped above the temperature of flash point.
     Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general. Therefore, 200m³ of ventilation quantity per 1Kg solvent (according to the solvent) is necessary.
   Protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eye protection, face masks, barrier creams and so on). If paint gets in touch with skin, wash fully with a large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately.
    Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in badly ventilated conditions.
    Handle empty containers with care and do not bring about environmental contamination..
    NOTICE: If consumers haven't taken effective safety precautions (Refer to the specifications), our company will NOT be responsible for any accident.